Automatic Multi-Photo Taker (Photobooth Style)

Many of these items aren't required. Mostly the Arduino parts are necessary, but you'll get to see when we use what as you continue reading. 

Electronics, Hardware, and Other Equipment:
-- Arduino Uno Microcontroller
-- Motion Sensor with PIR (Sparkfun)
-- LCD Keypad Shield
-- Custom Shield
-- Camera (I used a Canon T3i)
-- Remote Switch (I used a Canon Remote Switch RS60 E3. Note that this isn't wireless)
-- Resistors: 10K, 220, 220, 100
-- Arduino Wall Adapter Power Supply
-- Arduino USB Cable (2.0)
-- RGB Controllable LED (Common Anode) 
-- 1N4148 Diode
-- Ultra-miniature, Highly Sensitive SPDT Relay for Signal Circuits (G5V-1 Low Signal Relay)
-- Wires
-- HDMI Monitor
-- Mini HDMI to HDMI Cable
-- Small Circuit Board
-- Box (to contain your setup)
-- Screws and standoffs
-- Plastic Tie Locks
-- Circuit Board Tape

Tools:
-- Soldering Iron
-- Drill Press
-- Screw drivers (plus and minus)
-- Wire cutters
-- Wire strippers

View the original article here