Ever see an image on the internet and think,"Hey, that would look cool on a coffee table, or end table, or even a wall"? Well after paying $50 for a high quality laser cut stencil, I figured there must be a way to make one for a lot cheaper. And this is what I did:
PencilScrew driver (or paint can opener)
Paintbrush
Paint
Wood stain
Polyurethane
Spray adhesive
Scotch tape
Boxcutter or knife
Sharp scissors
Not pictured
Sheet of plastic or vinyl (thick plastic page covers or plastic file folders can be cut open and used)
Printer
Printer paper
Patience
No comments:
Post a Comment