Another DIY Vacuum Former

My goal was to create a simple and cheap vacuum former. I knew the sheets of material I would be forming would be 12in x 12in and so I would design the vacuum former around that . I came up with this design that follows similarly to many other DIY vacuum formers out there.

Design
A base board would have a hole in it for a household vacuum hose. A small frame would be built in the center of that measuring 11in x 11in. It would be glued to the base and then later sealed with caulk. A square section of pegboard would be glued to the top of that frame and act as the bed for the vacuum former. Separately, two frames made of MDF would sandwich the material to be vacuum formed and those would be held together with bolts. Some sort of rubber tape would run around the perimeter of the frame to form a vacuum seal. This frame with the material in it would go into the oven to heat the plastic and then be placed over the bed to form the part.

Parts
I bought the following parts from Home Depot for this project: 1x2-8ft Strip: $0.98 White Peg Board Panel: $8.45 3/8"-16 Wingnut (3 bags): $3.54 Hex Bolt, 3/8x2-1/2 (8x): $2.96 Foam Tape: $5.67 1/2" 2'x4' MDF Project Panel: $9.73 The following are extra parts that I used to make the table a little more user friendly and had lying around: 1x4-8ft Common Board: $4.12 3/4 PVC Pipe: $1.23 3/4 90º PVC Elbow: ~$1 The total cost before tax of this vacuum form system is about $38.

Tools
You'll need basic wood working tools for this one: a miter saw, circular saw, and a power drill. Wood glue is a must and caulking is optional but recommended. I found a Dremel was just fine to do the job of cutting the center out of the frames, but any method you prefer will work too. You may also want some type of square to make sure those corners are 90 degrees.

View the original article here