Though it was always on my to-make list, I probably would never have made this if it weren't for all the people asking for it after I published the Darth Vader Corky Instructable.Making Yoda was much more dificult than making Darth Vader, because I had to make him much smaller than Vader (he's still proportionally too big), and the head required much more fine sculpting. But, as Yoda said it, "Patience you must have, my young padawan".
The supplies you will need, these are. Hmmm.Craft knife Pencil Black permanent marker Brown permanent marker Black colored pencil Soldering iron Solder Paintbrush Acrylic/poster paints Ruler UHU Universal glue Krazy glue/ superglue Lighter Scissors Needle-nosed pliers Wire cutters Sandpaper File Wood glue Third hand Glossy varnish Champagne cork Green and brown sculpey (or Sugru) Scraps of brown and beige fabric Small nail Thin insulated wire Thin wire Aluminium tape Heat-shrink tubing Twig White artificial fur Positive battery contact Green 3mm LED Small button cells (not the ones in the photo) Small slide switch Small female connectors (I salvaged them from an old PCB) Also: Hotglue
No comments:
Post a Comment